Swann ADS-450 Spécifications télécharger pdf (Page 4)

Introduction

Congratulations on your purchase of this ADS-450 camera, the central component

of your SwannSmart Video Security system. This camera is versatile, powerful, easy to

install and congure and looks pretty stylish, too.

Best of all, it can be totally wireless - if there’s a WIFI network your camera can connect

to the Internet through, then just connect the camera to power and you’re good to

go.

You’ll be able to view images from your camera(s) from just about anywhere you can

nd a mobile Internet signal.

The Network LED will be constantly illuminated green when the camera is

connected to a network and is working correctly.

It will ash orange when the camera is connecting to a network - if the

ashing persists, it indicates communication diculties.

If the Network LED is red, this indicates that it cannot connect to the

network you chose, and probably needs to be re-congured.

The Power LED will be constantly illuminated green when the camera is

connected to power and switched on.

If this turns either orange or red, this indicates a problem with your power

supply - the camera is not receiving enough power. Ensure you’re using the

correct power supply, that the cables are undamaged and all connections

are rmly made.

The Local WIFI Conguration LED will be illuminated green while the

camera is set to Local WIFI Conguration mode (set by the switch of the

same name).

If this is either orange or red, this indicates a problem with the camera’s

built-in WIFI access point.

The Local WIFI Conguration Switch is located directly above the LED of

the same name. Local WIFI Cong will be turned on when the switch is in

the up position, and will be turned o when in the down position.

Reset: Located immediately above the Local WIFI Cong switch is the Reset

Button. Pressing this button while the camera is powered and operating will

clear all settings, and reset the camera to its factory default settings.

The button itself is located behind the small hole for protection against

accidental bumps or knocks. You’ll need a thin (but not sharp) object, such

as a bent paper clip or similar, to push the reset button.

1 2 3 4 5 6 7 8 9 ... 19 20

Pas de commentaire

Swann ADS-450 Spécifications Page 4