Swann DVR4-NET Manuel d'utilisateur télécharger pdf (Page 19)

3.TRIP Display

In Trip Mode, there will be eight pictures on screen, PB CH1~ PB CH4 are playback

pictures, CAM 1~ CAM4 are live pictures.

Push TRIP button or channel buttons to exit Trip Mode.

1.Back Panel and Connection Terminals

The power cord, camera input and video output signal terminals are all at the back of the

DVR4Net. The connections to monitor, camera etc are all handled through the terminals and

sockets on the back panel. The back view of the DVR4Net is illustrated as below.

System Connection

4.Hard Disk Connection

There are several steps to install the hard disk.

Note: If the DVR comes with a HDD, skip the following steps.

 Pull out the hard drive rack from the DVR

side panel.

2. Open the top cover of the drawer.

3. Jump HDD to Master

Jump to Master

4. Connect the ribbon cable (IDE) cable &

power cable.

5. Close the top cover of the drawer and put

the hard drive drawer back into the DVR. (Make

sure the cables are firmly pressed onto the HDD

interface)

6. Lock the hard drive draw by turning the key

clockwise.

Each part of the back panel is illustrated as

below:

1. DC Power Socket

2. BNC Video input 1, 2, 3, 4

3. BNC Video output

4. Audio input 1, 2, 3, 4

5. Audio output

6. RS485 screw terminals

7. Alarm output screw terminals

8. Alarm input screw terminals

9. +5V screw terminal

10. GND screw terminal

11. RJ 45 Network interface

1 2 ... 14 15 16 17 18 19 20

Pas de commentaire

Swann DVR4-NET Manuel d'utilisateur Page 19